How to remove data from a DVD to prepare it for a new record? How to clean the CD-ROM and DVD drive: Preparation and cleaning rules Cleaning a DVD disk.

If your DVD disk is not read on a computer or DVD player, then, most likely, the electronic media should simply be cleaned. There are several ways to eliminate traces of contaminants that prevent playback, all of them require extreme accuracy.

Instruction

  • To clean the DVD disc from dust, wipe it with a soft cloth from natural materials. At the same time, send your movement from the center of the disk to the edge along the radius, and not in the reverse order. It is not recommended to wipe the surface of the disk in a circle, since there are much more difficult to get rid of circular damage.
  • Try to blow away the dust from the surface of the electronic media using a special canister selling for these purposes in computer stores. Send a jet of air from the canister parallel to the surface of the disk and wait until the trace remains from the dust.
  • To remove fingerprints from the surface dVD Disc Or any other pollution, moisten a piece of soft tissue with ethyl or isopropyl alcohol, after which you wipe the electronic carrier dry with radial movements.
  • In order to carefully clean the DVD disk, moisten its surface with water, wash your hands and gently apply a soap foam on a brilliant side, then carefully rinse with water and blot with a cloth that easily absorbs moisture, such as a soft terry towel. Do not dry the disk with a hairdryer, it can damage it.
  • Take advantage of the glass cleaning fluid, applying it to a soft cloth and rub the surface of the disk in the direction of the radius. Or lower the DVD carrier into such a solution and leave it for 5-7 minutes, and then dry the disk with a piece of soft tissue from a natural material.
  • Take into account that solvents such as acetone, gasoline, kerosene, and other mixtures, as part of which are petroleum products, are categorically not suitable for cleaning the disks. They can clutch the DVD surface, as a result of which the electronic medium will become unsuitable for further use. Only solvents on alcohol should be applied.
    • Tip added February 16, 2012 Tip 2: how to clear CD CDs are used, in particular, for long-term storage and transfer of computer files. The more actively the CD carriers are used, the more relevant the task of periodic surface cleaning becomes. To solve it, you can use both special sets of industrial production and remedies. In addition, under cleaning disks, they do not always imply their surface, sometimes we are talking about their contents.

    Instruction

  • Buy a special set to care for optical discs, which includes necessary components To clean the surface of CD / DVD carriers. As a rule, the packaging contains a bottle with a special liquid and a sponge or a set of disposable napkins. In addition to them, the set may include a canister, which allows the "blow dust" from the tracks of the optical disk in the direct sense of this expression. Moreover, the basis of some sets is automatic devicein which the accompanying consumables And place an optical disk, and the device itself will produce the device without your participation. The most simple of the sets contains a number of disposable napkins impregnated with a special liquid.
  • Find a soft cotton napkin that does not leave the fibers, if you purchase a special set is not possible. As a detergent fluid, you can use conventional water. Means for washing glass is also suitable.
  • If the set is intended for manual cleaning of optical disks, make it movements from the center to the edge - the probability of applying mechanical damage to the circular motions is much higher. After the completion of the procedure, the CD should be dry. If you used special materials from the acquired set, then the liquid evaporates from the surface itself. Otherwise, wipe the disk with a dry cotton cloth with the same radial movements.
  • Take advantage of any application for the location of the optical disks, if the CD is not in the cleaning, and its contents. But first you should find out whether such an operation is possible in principle. The prerequisite is the presence of a CD / DVD drive in the computer. In addition, the CD itself must be designed for reuse. If there is a letter W in the CD marking, then this condition is observed. Another possible obstacle - if in the process of the previous data record on the disk it was "finalized" (the corresponding label was set in the recording settings), then no changes in its content are now impossible.
  • When installed one of recent versions operating systems (for example, Windows 7 or Windows Vista.) Use its own components to clean the disk directory. Download the CD into the reader, start the conductor and click the icon optical drive right-click Mice. IN context menu Select the "Format" string and a window will appear on the screen with the disk cleaning settings. You don't have to change anything in the default settings, click the Start button and the CD formatting process starts.
    • Sources
    • how to free a CD
    How to Clean CD - Print Version

    Many users prefer to buy rewritable discs to be able to record information on it several times. But before cleaning the DVD RW disc from the information, it is worth choosing the most suitable way. You can make it possible using some disk recording programs or you can use the tools installed on the computer operating system.

    If not installed programs To record disks, you need to go to the "My Computer" section, and in the window that opens, find the CD / DVD drive icon.

    We carry the mouse cursor on the drive icon in which the disc is in need of cleaning.

    Press it right key mouse.

    In the drop-down menu, we find a string where it is written "erase this DVD-RW", after which we press the left mouse button on it.

    The CD Wizard window will open, in which you need to click "Next".

    All files located on this disk are deleted. This process can take from a few seconds to several minutes, depending on the number of recorded files and the speed of the rewritable disk.

    After the disk cleansing is completed, the "CD recording wizard" window will be information that the operation is successful and the media is now suitable for recording new files. Here you press the "Finish" button.

    If, after executing the above operations, it has not been cleaned, it may mean a malfunction CD / DVD drive, or the disk can be more unsuitable for subsequent recording.

    Clear DVD-RW drive is possible very quickly and simply using Ultraiso or NeroburningRom programs.

    To use Ultraiso to clean the disk, you need to select the "Tools" menu in the open window, and select the "Write the CD image" in the drop-down menu.

    The "Record Image" window opens, in which we click "erase".

    If the NeroburningRom program is installed on the computer, select the "recorder" in the open DVD-RW disk, and press the "erase rewritable disk" in the drop-down menu.

    In the window that will appear after that (erase a rewritable disk), select the drive, the method of cleaning the disc and the rate of erasure.

    After pressing the "Erase" button, the process of cleaning the rewritable disc will begin.

    When cleaning the DVD-RW discs, it is necessary to fulfill the complete erase of all files. This will help exclude the reading of old data in parallel with the reading of new recorded information.

    In the case when the disk was cleared not immediately or not from the first attempt, it should not use it, as this may lead to loss of information that will be recorded later.

    Hello everyone. In addition to cleaning CDs with water with soap, there are plenty of other effective ways. This article will tell you about how and what to clean CDs (CD and DVD).

    Often, many people have a situation when they put a computer or player drive, and he freezes and "does not want" to play, or plays, but "urabs". What is it caused? First of all, the incorrect disk handling or the fact that the disk is used for a very long time. If scratches were formed on the surface of the disk, then the likelihood is that it will be incorrectly reproduced. In such cases, cleaning can help, although the success of this case will largely depend on the degree of damage to the disk cover. There are many "folk" ways to clean up CDs and DVDs, some of them are capable of surprising with their fiction even experienced and experienced users.

    How to Clean CD or DVD?

    Use water and soft tissue.
    First of all, well rinse the CD. This is done in order to remove dust from the surface, adhered particles and fat stains. Immerse CD or DVD in warm water, hold them there for some time, then take a soft fabric without a pile and wipe the surface of the CD. Do not trite surface too carefully and rigidly. In order not to damage the data on the disk, there is a specific "pattern" of cleaning actions. When cleaning, you need to start from the center of the disk and move to the edge. Never use towels, toilet paper, paper towels or any other materials and things that can cause the appearance of small scratches on the surface of the disk. Give the disk to completely dry, and then check whether the data is correctly read from it, whether it works without failures and pause.

    Cleaning the disk surface .... Banana.
    Most users do not even realize that it can be used to clean the scratched disk ... Banana. Take the fresh banana and cut it into two parts. Wipe the CD / DVD disc surface with circular movements. Next stepIs cleaning the surface of the disk with a soft cotton cloth. Before starting the disk playback, it will be better if you use the cleansing sprays and after the disperse disk with a dry and soft cloth.

    Application of toothpaste or vaseline.
    The disc surface can also be cleaned using some household items, such as toothpaste or vaseline. However, this method can be used if scratches are not too deep. Put the appropriate number of any of these products on the surface of the disk and wipe it carefully with a soft cloth. After, for final cleaning, use the cleaner spray, wipe the disk dry and try to play it.

    Use a polyrolol or special cleaner for disks.
    If the above funds were powerless, it is possible to use a metal polyrolol or a set of cleaning agents for disks. Prothe wheels with a cloth with a polyrolol applied to it, after wrench the disk with a soft clean cloth, let him dry, and then try to reproduce it. If he and then does not work properly, try the latest possibility, use specialized disk cleaning fluids.

    These are just a few funds that make it possible to effectively clean the surface CD / DVD discs. There are other ways, for example, the use of alcohol, soda as a cleansing agent, soda, etc.

    Although the DVD is already cutting into your age, however, they still have on many computers and laptops. Many have licensed windows systemwhich is stored on the disk, and it requires a DVD drive (although it can be installed from it). Therefore, I want to consider in this article, as you can, with simple tools, clean the DVD drive in your computer or laptop.

    The method that is described below, I have been using for many years and has shown myself very effective.

    The reason that the DVD drive began to work badly, do not read discs or do it with interruptions, most often - the dust hitting the laser lens. Here we will clean her.

    Required tools:

    • Philips screwdriver (cross);
    • Ordinary clip (it needs to be dispersed);
    • Cotton swab or wand.

    Instruments

    How to clean the DVD computer drive

    To begin with, remove the DVD drive from the computer. It is not necessary to do this in the laptop.

    I turn up upside down and unscrew 4 screws that mount the lid.

    Unscrew the screws

    Very carefully remove the lid and postpone. Our attention will be a board with electronic components.

    Lower DVD-ROMA

    Now put the drive so that he watched the front panel to us. Our broken clip insert into a small hole intended for emergency opening of the drive tray. Boldly give a clip until the tray does not come out of his place.

    Davim here

    I pull out a manually tray about half of its length. Now remove the facial plastic panel. To do this, you can press the side latch with a screwdriver.

    Face panel side latches

    Remove the panel

    Now we turn the drive to the lid down and carefully remove it from there.

    Delivery dVD drive from the lid.

    Now you can see the same laser lens that need to be cleaned. Carefully consider it. Most likely you will find small hair or dust on it.

    Do not try to remove contamination with your hands. May remain fatty divorces that will be difficult to eliminate.

    We take a cotton wand and lightly smile with a lens pollution. It is not necessary to polish the lens, it is enough just to remove dust and hair.

    Clean the lens with a cotton wand

    It may happen that we bought a movie, looked at him and gave to watch their friends or acquaintances. Then after returning the disc, he suddenly stopped reading.

    What happened? We open the drive, carefully look at the disk and disappointment we see that there were scratches on it, which was not there before, but what is even more strange: he is some kind of all overlap, something smeared, all in some dried spots. How does he read the poor? Just the child of friends was inaccurately entered with him: let's say, threw the disk on a dirty face on the front side down, and even God forbid, at the top I put some item on it and tried on the table.

    In no case do not wipe the CD Some napkins or rags - you can scratch even more (damage) the work surface of the disk ...

    Well, with scratches, nothing will be done. If they are insignificant, the disc will read. But remove dirt from the disk by car wash in warm water with soap. Yes, as an ordinary plate, only with your hands, not a cloth or sponge.

    We wat the usual water and neatly soap solution distribute over the surface with a soap hand. Simply put, good my hands before complete removal Dirty spots.

    Finish, washed:

    Then it is easy to simply shake and give dry, but if the water is rigid, but after drying there may be traces of stiffery salts. We simply wash the well absorbent moisture to matter, for example, a terry towel:

    It is advisable to absorb, wipe the CD / DVD disk, do not. Any friction on the working surface of the disk is fraught with its scratch, suddenly the sands remained in matter? So miss safer:

    And hands do not need to touch the work surface if possible:

    Give a few dozen seconds to dry the disk and that's it. Disk ready to use. Try it, it can happen that those discs that have not read earlier will be successfully read in your drive.

    By the way, if most of the disks from your collection are not read in the CD / DVD drive, then check on another drive, let's say from familiar or friends. It may happen that it is time to change the drive due to the mechanical shift of the reading head relative to the surface (they say that "the eye has rushed").